Digitus DS-14210 Specifiche Scaricare il pdf (Pagina 15)

DIGITUS

KVM Switch Module for modular based TFT consoles

A Module as a Slave or a Stand-alone KVM Switch

A slave DIGITUS® KVM Switch Module (see Cascade Configuration chapter) may

be mounted to the rear vertical poles inside a rack cabinet by the rear brackets with

connectors to computers facing rear, as shown below.

Slave DIGITUS® KVM Switch Module and Rear Bracket Attachment

The connectors (keyboard and mouse) at the Local port on the rear of the KVM

Module are not applicable when the Module is connected to the TFT LCD drawer by

the C-36 connector. When the C-36 connector is not connected to the TFT LCD

drawer, the DIGITUS® KVM Switch Module acts as a rear-mount stand-alone KVM

Switch Module. The VGA ports at the Local and Remote can be connected to

external VGA monitors at any time.

Initial Power-Up

Make sure all computers and DIGITUS® KVM Switch Modules are powered

down during the installation. You must power up the Master DIGITUS®

before turning on any other devices.

n For single DIGITUS® KVM Switch Module:

1) Apply the proper power to the Master.

2) Turn on computers.

n For cascaded DIGITUS® KVM Switch Module:

1) Apply the proper power to the Master.

2) Apply the proper power to all Slaves.

3) Turn on computers.

Note: You may hot plug additional powered-down computer or a slave DIGITUS®

KVM Switch Module without turning any existing DIGITUS® or computer off after

initial power up.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 32 33

Nessun commento

Digitus DS-14210 Specifiche Pagina 15